When modeling a loop ramp (or any situation where the alignment doubles back on itself) point controls and target aliases have a tendency to find solutions that are technically correct across the infield but that are not the intended solution. For...

In OpenRoads Designer, applying a Z offset to a reference file only affects the display of geometry and does not modify the underlying element elevations. In the model: A 3D reference is attached and adjusted using a Z offset (-0.105 m) to corre...

while importing point data we have option to import data as northing easting and elevationsuppose we have data that rock surface is ∆z below the existing ground so before importing point I should have option to select the existing surface so that ...

Need a way to get returned values from an expression to appear on individual lines with the use of a carriage return. In Microsoft Excel, you can do that by pressing Alt + Enter within an active cell.

Summary: When users turn levels off in the Default 3D models, that display state does not carry into cross section drawing/sheet models without opening them more than once. This creates unexpected sheet output where items that are intentionally hi...

Older back-and-forth data transfer feature from AASHTOware BrR to Leap/Conspan is not available in current release. Such a link in between former CONSPAN and AASHTOWare did exist in the past. This link could not be effectively maintained and in co...

Deck Slab Reinforcing Steel is offset when the slab geometry is not rectangular or tapered. I have a tapered bridge and the slab follows the tapered edge but the reinforcement follows the alignment and not the edge of slab. Is there a way of forci...

The nesting depth on newly created Drawing and Sheet Models defaults to 99. I have set up my sheets seeds the way that I would like the nesting depth to be set. For Plan and Profile Sheets, the Default model of these sheets acts as the "container ...

OpenRoads Designer currently lacks a workflow to apply spatially varying Z corrections derived from a mesh to existing geometry, while preserving the X and Y coordinates. This is helpful for situations like in point‑cloud‑driven workflows, users f...

The Reports tool I am talking about is the one in Utilities and in the Explorer and not the Horizontal Geometry report. Currently, this tool enables only to report the properties (such as the length, direction and etc.) of the linear elements and ...