We need the ability to get the profile elevation from the turnout points to the turnout report.

I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...

Use the Geometry Connector with start and end elements chosen as turnouts. The converged result gives a disconnection between the regression alignment and the turnout. You can only discover it by zooming in to the closest possible view. A "Verify ...

Especially in reports but also in models we need to add information about turnout type including a letter showing towards which side looking from point 1 towards point 2, the branch is oriented. As it is now turnouts with Leading orientation will ...

Possibility to add/remove/change length of long sleepers sets in turnouts that are placed in a geometry. When you are working with existing geometry and there are turnouts with too long sleepers sets or if you by mistake place a turnout that has a...

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...

Currently one could add an LLS part on a turnout. Unfortunately this is a standard value. Sometimes, when creating a horizontal geometry, it is necessary to ''shorten'' the LLS part (aka to place a fewer amount of long sleepers that a standard LLS...

Users need a way to annotate the same way SS2 would annotate with the Switch Height Plan command. Partial lengths along the alignment need to be annotated, but there is not a way to do this in OpenRail. The workaround is to create a dummy alignmen...

To comply with US railroads standards, we need to place agency-specific cells at the turnouts. The cells must snap to either PS (point .1) or PITO (point .0). Right now these points are not snappable, neither graphically identifiable which makes m...

The idea is similar to parametric civil cell: we need a tool to place the ties along the turnout. The ties must be of different lengths, placed at different spacing, and must follow the alignments from and to specifically identified points. The ti...