I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.

I have tried using the line integrals for shell elements in RM Bridge, but the results are not accurate by around 10%. This is not acceptable. I was told by Ana Carla that the linear integrals results come from Gauss points integration, but I do n...

When comping existing alignments, we have a need to match the overall Spiral PI data. Adding this to the Report would make the workflow easier.

In Geopak, there was a tool under DTM Tools > Analysis > Volumes, where you could specify elevation ranges to calculate the volumes, while also taking into account the volumes between two TINs. You were able to specify multiple contour inter...

Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.

In LEAP Bridge Steel, include an option for the analysis reports and diagrams to include total reactions from factored load combinations. The current reports only provide unfactored reactions for individual load cases which leaves the user to manu...

Current report only reports XYZ of the point and station along alignment. Elevation on reference is basic information needed. Unfortunately civil expression in item type doesn't work in 2024 to workaround (CivilExpression.ElevationStart(this."Refe...

OBM has the option to create a deck elevation report parallel to start of the support or normal to the alignment. Bentley should include the option to find the elevation and station of the bent traverse line to not intersect with the railing lines...

The current report has the Start station, but it would be nice to have the Ending station of the individual elements included as well.

In ORD 2023 there is no provision for manually adding non-modelled cut or fill volumes to a mass diagram or earthwork report. Manual volumes are typically used for borrowing sites, waste sites, non-modelled bridge embankments and merging models su...