When you place a Linear Template on a splined element a warning is generated which requires user interaction to dismiss: "Warning: The base geometry selected for this corridor contains B-Spline elements for the horizontal Transitions. Consider rec...

The elevations of the event point can only be seen when one generated a Horizontal Alignment Event Point List Report. It would be better also if the elevations can be seen earlier in the Event Points List Table

I have a horizontal and vertical alignment with a shift. If you load the vertical alignment into the table editor, it does not load all the VPI's. It skips one of the VPI's at the shift location. Also, if you export the vertical alignment using th...

I'd like the ability to change the Northing and Easting columns in Table Editor to show Y and X instead

In ORD it is possible to do a Profile Offset Transition. This methode makes a vertical offset. In case of a slope, the difference between the vertical offset and the normal/parallel offset is different. For large slopes, this is differences is too...

OpenRail Designer seems to have Japanese Sine spiral type added from the formula used in Power RailTrack. However, there seems to be nothing similar to Japanese Cubic Parabola, which is based on a different formula from Japanese Sine.

Create a best fit vertical profile and then convert to a Profile Rule. It only creates parabolas ... we need the ability to create a circular vertical curve. The profile by Best Fit command may only utilize parabolas, but they ONLY work with circu...

As an MX user, we had the ability to lock stationing to an xy coordinate in an alignment. Please add this ability in ORD. An example use would be as follows: the user has a complex horizontal alignment, vertical alignment, and wants to append a ta...

Currently, The 3D cut does not work on the closed alignment's profile model. This is required specially in the case of Roundabouts. We can not create a 3D cut on the Roundabout profiles.

When creating parcels in Geometry Builder, I would like the option to have it automatically add COGO/Geometry Points at the PIs and on-alignment points as I place the elements.