Civil cells does not support turnout or crossing elements. Ability to include turnout and crossings in civil cells, will enable creating civil cells for siding and yard areas.

It is my understanding that this was removed in the 2024 version due to general confusion, but I'd like it to be added back. If it is made toggleable, it can be turned off by default to avoid the aforementioned confusion, and this allows those tha...

In ORD it is possible to do a Profile Offset Transition. This methode makes a vertical offset. In case of a slope, the difference between the vertical offset and the normal/parallel offset is different. For large slopes, this is differences is too...

We have many users on the survey side that need to quickly jump in a design file and export out an alignment xml for staking. Non-Roadway users do not have write access to these files and the export geometry tool cannot be used in a read only file...

The ability to hold geometry segments and geometry segments end points when doing an adjusted. For example, if I have surveyed monuments I would like to hold to but adjust the rest of the geometry that is not held to a monument.

Some users need to be able to assign unique point numbers. So, when creating a new geometry point, the user should be able to type in a starting point name/number (with or without a prefix) and once they place that point, it should automatically a...

There are quite a lot of situations we need to edit element lengths (shorten or lengthen) by fixing their stop ends, which can be done easily in BRT; However, I couldn't find similar tools in Openrail to solve it. Can Openrail improve the table ed...

In the Geometry Builder Edit, I can pick multiple geometry complex alignments and add them to create a 'combined' geometry. When I pick the multiple geometry elements and combine them, it starts with the alignment stationing of the first selected ...

I would ensure that my vertical and horizontal alignments are the same length by using the Trim/Extend buttonn in geomtery editior in Power Rail Track - can we have the same functionility in ORD please? I know I can snap vertical alignment to the ...

Geometry/Lines requires you to enter the bearing value as S45d30'30"E which is way too many key strokes and unproductive. Geometry Builder allows us to enter the same bearing using the quadrant method (245.3030) which is much faster/easier and ali...