To have to go to the Back Stage and select Settings ==> File ==> Design File Settings ==> Civil Formatting ==> Degree of Curve Method to change from an Arc Defined Curve to Chord Defined Curve is not a good workflow. In our State we ca...

Similar to the plan and profile Civil Accudraw, it would be useful to have a tool to be able to view offset, elevation, and slope in the cross section interface. This is desired in the dynamic cross section view, where users could actively utilize...

Currently in the XSection viewer in OpenRoads Designer if you have a corridor or linear template that touches our butts up against another corridor you can't place temporary dimension lines on those components to make measurements if the linear or...

The current IFC exporter only exports using the actual elements symbology and ignores Level Overrides, Reference level symbology changes, etc. This makes it very difficult to control, requiring users to actually physically edit the elements in the...

In modeling the road or site with geometry corner in 90 degrees or sharp, the small arc of corner is required in order to model the round corner. So that no overlap between 3d linear geometry. Software should provide the option to allow the corner...

Currently, Drawing annotation for Cross Section is only available for Ground Z and (design) Z. If there are multiple stratum and terrain models, no direct option to annotate the height/offset difference from design to other stratum, or stratum (te...

Add the conduit table options similar to drainage for managing conduit sizes, materials, etc... Right now you have to input a conduit table for each utility type and can't import a table from utility to utility. Just need one set of tables to mana...

Currently, when one uses the create regression line from rails tool, the points that the program creates are 2D, in other words they contain only X and Y, not Z. It would be nice to create points along with the regression line that contains also i...

When opening a DGN file, have an application read the schema and then open the corresponding version of software. Currently, users with 'side by side' installation of ORD have to manually decide which product to open each time, and memorize which ...

It's a little cumbersome to keep going back and forth between models when developing annotation groups. An alternative could be to be able to select the geometry that is shown as the example when in the annotation group manager.