I would like to make a suggestion on an improvement to template design for 3D Modeling in ORD. The Rollover values tool in superelevation template design is incredibly helpful, as it saves time by calculating the proper shoulder super rates accord...
Want the ability to annotate every special point of the horizontal & vertical alignment with a number in sequence. You can veiw a sample of the profile annotation needed in the image below or in the PDF attached. This type of annotation is com...
almost 2 years ago
in Annotation
0
Future consideration
Automatically calculate values when inputting into property fields
When inputting numbers into property fields, ORD can automatically calculate them for you. Example: Survey field team shoots the top of casting elevation of a manhole at 500ft, then shoots again for a bottom invert of the manhole but only leaves a...
This code would be similar to the DIST command, except it would allow the crews to add a taped distance to the last segment of a figure, which would extend that segment by that value. It would be similar to a DIST commend except instead of turning...
Fix DIST Command in Survey to InRoads Survey Operation
The DIST Command in Open Roads is almost identical to the InRoads version with one problematic exception. Open Roads uses the last two actual shots to determine the direction to turn the 90-degree angle to generate its points. InRoads would allow ...
Add Single Point Arc that is identical to InRoads Surveys
The Sigle Point Arc command in InRoads survey would create true tangent arcs from the incoming and outgoing tangents. The ArcSingle in Open Roads does not. This frequently results in bulges in figures if the uncoded PC and PT points are not perfec...
Option to Edit the Loads Font on Leap Conc -> Sub -> Geo Tab
I would like the option to edit the font on the Leap Concrete, Substructure tab, Geometry Tab. This way the text displayed that shows the loads can be increased which can help when saving images for review and record keeping. Thanks