We connect the pipe at the center of the node, and we are seeking functionality that allows the drainage properties to automatically calculate and display the inlet and outlet elevations at the inside wall of the node (see picture).

For nodes, the road construction depth is calculated in the export Vejvand process – it’s not available in the ORD user interface. Also, the Formatted PostNr is updated during the export process. The export process can do a lot more than UDX formu...

Revised Justification for DU Cell Enhancements If Drainage and Utility (DU) cells could incorporate linear and point features, these elements could be utilized as break lines within graphical filters for terrain modeling. Additionally, such featur...

Have the auto annotate toggle (in the feature definition toolbar) work when placing nodes and conduits that have an annotation group linked through the feature symbologies.

In Geopak Drainage, once you place a node and attached a catchment, you were able to see inlet calculations. This let the user know if they needed to shift the box to have an allowable spread. It would be great if we could get that feedback withou...

Geopak is no longer supported by Bentley. At some point, Geopak will not be installed on our machines, but we may need to get the calculations that reside in the GDF file. We need a method that will allow us to extract the information we need from...

The current prototype creation and editing process is highly manual and lacks efficient management capabilities such as mass editing, sorting, filtering, and rearranging of information. As a result, users must individually update entries, which be...

Currently the Node-Connect Pipe Flex Table can report -Pipe- Label, Description, Rise, Inverts (Start & Stop), and Size. It would be useful if the angle of each pipe could also be included. Often in design need to verify a minimum distance bet...

It would be extremely helpful, if we were able to programmatically create Feature Definitions and Feature Symbologies so that automation of the creation of new 'Custom Drainage Features' every time a drainage structure had a different bottom box (...

A new annotation filter setting (Label) was introduced in OpenRoads 2025. This setting works well to place callouts for corridor components, however when drainage/utility features are selected, we run into issues as shown below. The callout does n...