Need Support? Let’s guide you to the right answer or agent.

OpenSite Ideas Portal

ADD A NEW IDEA

Geometry

Showing 157

horizontal regression for points

in Inroads there was an option to select points to put in regression in geometry to create a best fit alignment. You could then do a single element regression analysis afterwards and it would give you the best fit line and how far in either direct...
over 1 year ago in Geometry 2 Already exists

Profiles and Sections with no sheets

I am going back to the SS2 versions. I would like to see an option to produce 1 profile for the entire alignment. Give it the station range and produce the profile in Microstation with an option to annotate The same for Cross-Sections. Station Ran...
about 2 years ago in Drawing Production / Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Option to set station limits while creating Curvature Diagram.

I want option to set a station limits while creating Curvature Diagram so that we can focus on a very specific area instead of the whole geometry.
about 2 years ago in Geometry / OpenRail Designer 1 Future consideration

Auxiliary Lane Analysis with Speed Profiling

https://www.civildesigner.com/auxiliary-lane-analysis-with-speed-profiling/ Speed Profiling When considering the location of climbing lanes the civil engineer will combine an analysis of the size and length of the grade change with the speed profi...
over 1 year ago in Geometry / Modeling / OpenRail Designer / OpenRoads Designer 3 Future consideration

I need to create a quick profile that can be graphically manipulated BEFORE I create a corridor or do any detailed design.

The Bentley training videos all create a corridor and cross sections before a profile is created that can be edited. I need a profile of the existing ground BEFORE I do any detailed vertical profile design. That way I can see if it works visually ...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 3 Already exists

Add reading/editing alignments with shifts with table editor

I have a horizontal and vertical alignment with a shift. If you load the vertical alignment into the table editor, it does not load all the VPI's. It skips one of the VPI's at the shift location. Also, if you export the vertical alignment using th...
5 days ago in Geometry / OpenRail Designer / OpenRoads Designer 0 Future consideration

Table Editor (Vertical/Horizontal) Ability to Customize Columns

I'd like the ability to change the Northing and Easting columns in Table Editor to show Y and X instead
6 days ago in Geometry / OpenRail Designer / OpenRoads Designer 0 Future consideration