Users should be allowed rename the Bearing group names and the individual bearings in a group.

Using OpenSite Designer, is there a way to hide items, i.e. pipe, valves, and equipment, below a surface? These components are on multiple elevations above and below this surface. All components are on the same level, i.e., WATER. Client does not ...

When you create your corridor, and ultimately move towards creating a terrain model, you would especially want the model to create the high points and low points correctly as this critically effects drainage design. However, the only way to force ...

ability to see list of items with no feature definitions selected.

When using Create Template dialogue, it would be a good feature to have a section or list that could be pulled showing all of the templates used in the project folder.

there is no good tool that we have found that allows you to analyze plan, profile, xs simultaneously with sta/off & elev information.

Ability in surface creation to move backward. For instance, proposed top mesh for retaining walls will never be correct, because the coping and barrier wall being outside of the wall requires the surface to move in the opposite direction. This can...

In ORD 2023 there is no provision for manually adding non-modelled cut or fill volumes to a mass diagram or earthwork report. Manual volumes are typically used for borrowing sites, waste sites, non-modelled bridge embankments and merging models su...

Add a Surcharge Volume Option for Meshes & Terrains. This would need to function so as to compare the Surcharge to Design and Existing volumes/terrains. Surcharge embankment will always be above finished or existing grade, so consider this as ...

Ability to set a target point that the tool fixes on when driving down the alignment.