In Geopak, we had the ability to take individual alignments and create an overall alignment from a subset of alignments and it would hold the individual stationing for each alignment, creating station equations. There is no way to do this in ORD u...

The existing Locate Point tool using the Traverse and Radial methods functionally does something similar, but must have 180 degrees added manually to the deflection angles to get the absolute angle.

What I envision, would be the ability to define Math within a Text Favorite. So, let us say that "[[" would define the start of math in a text favorite. A text favorite could be created in that the value displayed, is math from element properties....

Whenever you have a Geometry and used shared line (e.g. Lots), There should be a tool to remove duplicate/overlapping lines. Its problematic if we use a special linestyle with gaps and when the two line on top of each other it will look like a sol...

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

When a custom line style is updated in the workspace, it does not update existing files that have used the previous line style (of the same name). The only workaround is to: Manually delete all of the line styles you want to update Remove the defi...

When creating parcels in Geometry Builder, I would like the option to have it automatically add COGO/Geometry Points at the PIs and on-alignment points as I place the elements.

The "Set Feature Definition" Tool should be added to the Feature Definition Tool Bar rather than having to go digging around to find it. It coincides with "Match Feature Definition" which is already part of the tool bar.