Profile Elevation Labels - just the middle major gridlines
City of San Diego doesn't currently label the Profile Elevations of the bottom major gridline and the top major gridline. OpenRoads doesn't differentiate between top and bottom and middle major gridlines. A toggle to disable Top and Bottom would h...
Ability to save frequently used slopes in the "create slope to target" tool dialogue.
It would be very helpful if we could save our frequently used slopes to a pull down list in the "create slope to target" tool dialogue. Currently you have to type in your desired Cut and Fill slopes every time you use the tool. It would be much be...
Allow Vertical Scale in Profile View to Stay Set after "Saved Settings" Or Change Default to 1
Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...
Add ability to match level when importing features from graphics
When I import features from graphics into a field book, the program does not set the correct level (match level) for most features. If we can get it to match the level correctly, it would save a lot of time. To take it a step further, it would be ...
Ability to update profile drawing model element annotation without removing full model annotation.
Currently, the software does not respond to removing element annotation in the profile drawing models. Instead, the entire model needs to have annotations removed, re-annotated, and then the individual elements need to be annotated.
Placement Point for design and baseline Station/offset
The optimal placement point for design of drainage nodes not always the preferred callout point for construction. The request is to be able to have an additional "Construction" layout point to get station and offset reports that are different than...
In profile view, the top of Transition Node is tied with group elevation; and bottom elevation meet the pipe. Any chances to make the only “Transition Node” showing as “point” or “line” only in Profile? J ust only one point in the invert? Setting ...