There is no civil geometry property exposed for "Arc Begin Point Label" or "Arc End Point Label". This leads to a discrepancy in the way that points are labeled for PCC and PRC on the alignment when compared to the curve data table. These annotati...

There are some regression tools that were ported from openRail into openRoads in previous releases. However, they didn't port every regression tool. Most notably, they did not port the Vertical regression tools for creating a regressed profile. We...

PowerInroads used to have a built in calculator/analyzer. It helped us to quickly calculate the drainage pipe information, minimum slope and velocity at full value etc. Currently to get the data, we use Flow Masters and manually calculate each pip...

There is usually more than one option for inlets which have different capacities. It would be helpful to have the software select from these options to reduce errors. Also nodes often need to be increased in size when a pipe exceeds the size of th...

With the increase in requirements of information to be provided with models it would be easier to have both of these the same so the coding could be shared.

In Geopak, we had the ability to take individual alignments and create an overall alignment from a subset of alignments and it would hold the individual stationing for each alignment, creating station equations. There is no way to do this in ORD u...

I would highly recommend to let user to snap to arc or spiral end in profile design. As you can see in the attached video I can't find intersection between profile alignment and vertical line that indicates arc/spiral end. To find intersection b...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...

When creating named boundaries of any time, a saved view is created for each named boundary. The creation of a saved view is a method that is supposed to control the look and feel of the drawing/sheet, but it is over-complicated, poorly understood...