CS0152823 "This user is suggesting to add a note that our STM analysis and design method is based on which AASHTO Code edition. " To add a note regarding LRFD-9 STM changes in output results report

End Area Volumes are still a contractual requirement on projects. We need a tool to correct the earthwork calculations around curves like the GEOPAK “Centroid Adjustment” tool that did that correction and provided a summary of the centroid locatio...

OBM is limited in the cap shapes it can accommodate currently. It would be very helpful if we had the ability to draw cap shapes in the front elevation view and use those as templates, which OBM extrudes in the up/downstation direction. We would l...

In the loads tab provide an option to specify that a load is part of the self weight. between the internal concrete block outs, and sometimes having geometry that doesn't perfectly match the library beam self weight, it would be helpful to be able...

Provide a way to quickly apply additional loads that are either composite, or specific to a beam. Include the ability to specify which stage the load is applied during. This would get used for loads such as additional overhang concrete, utilities,...

The output reports for a bridge in Leap Bridge Steel is thousands of pages of poorly optimized tables. I have used other software (including LEAP Bridge Concrete, Merlin DASH, etc.) that provide a lot of the same necessary information with much mo...

When using the Transpose tool, the software makes a copy of the element you are selecting to transpose, and that is the element that is reversed, leaving behind the original underneath. Most of the time I do not want a copy of the transposed eleme...

File branding by Product is problematic for Organizations where multiple software solution are deployed like OpenSite, OpenRoads, OpenRail and OpenBridge. The schema(s) within the file should be analyzed at file open rather than the last authoring...

It would be very useful to big back the user option for stroking linear elements when creating terrains. This was available in v8i and greatly enhanced our surface models. Right now there is a configuration variable but it can't be set by users. A...

We often want to show the location of cross section in plan which can be done using the named Boundary Lines but they need to be annotated so you know what each represents e.g. stations/chainages or section names such as letters etc. There is a wo...