There used to be a tool in InRoads (I think it was part of the Generate Longitudinal Feature) where you could project the slope between 2 elements onto a third element. The is no such tool in ORD. The only way I can figure to do it now is to creat...

Add ability to copy points, components and sets of components

When using Set Feature Definition (FD) or change FD in Properties dialog, to assign / change a FD to a Complex Geometry, such process only affects the Complex Element entity itself, i.e. FDs of all geometry elements which the complex element is ma...

Service load cases are optional for legal and permit vehicle ratings for prestressed girder structures, but are required for the design vehicle. Currently, two analysis runs must be done to get ratings for design, legal and permit vehicles; one ru...

Make Cross Section to Surface tool available on newer versions of OpenRoads Designer. This tool was available on InRoads.

When you place a Linear Template on a splined element a warning is generated which requires user interaction to dismiss: "Warning: The base geometry selected for this corridor contains B-Spline elements for the horizontal Transitions. Consider rec...

Current OpenBridge Modeler version don't have ability to model horizontal cross bracing.

Let's say there are 4 spans and the user defines a bridge with 5 supports and the deck and beam groups run from support 1 to support 5. Then the engineer learns that we don't want this long of a bridge, only 3 spans. Please add the ability to chan...

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...

This won't update immediatly when the 3D model is updated. This means that when going to plan production, all profiles needs to be refreshed.