When using "Extract From Graphic" tool to create a drainage or utility model object, the extraction process fails to bring the Item Type from the source object (in this example a surveyed gas line), leading the user to reattach the Item Type to th...

Right now section strand patterns can be input and chosen from automatically by the auto design feature, but I feel this is a bit backwards thinking. Rather than inputting all possible strand patters why not set a template strand pattern with as m...

Now that the Civil Labeler definitions are stored within a dgnlib, i think it would be really useful to combine some functionality. Annotation Groups allow for annotating with text, cells, or lines. Adding with Label Definition would allow an anno...

To have to go to the Back Stage and select Settings ==> File ==> Design File Settings ==> Civil Formatting ==> Degree of Curve Method to change from an Arc Defined Curve to Chord Defined Curve is not a good workflow. In our State we ca...

Currently in the XSection viewer in OpenRoads Designer if you have a corridor or linear template that touches our butts up against another corridor you can't place temporary dimension lines on those components to make measurements if the linear or...

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...

It's a little cumbersome to keep going back and forth between models when developing annotation groups. An alternative could be to be able to select the geometry that is shown as the example when in the annotation group manager.

At present, the Deed Writer tool describes boundaries only. We should be allowed to use this tool to also describe easements and acquisitions. For example: If an easement is necessary to be described along the centerline of a sewer pipe.

The ability to target multiple Horizontal Feature Constraints for a template point and set priority on those individual Features. Similar to Target Aliasing.

The manage annotations dialog that is used to create Annotation Definitions automatically saves any changes made. If the dialog is closed then all of the changes are saved even if there was not an intent to save them. Please add a save button or a...