The raw-xml is missing Latitude and Longitude information when creating reports. InRoads had this capability, but it appears to be missing from OpenRoads.

Hi, We are struggling with sight visibiloty analysis, because currently available methods covers only some of regional standards, like for example Italian, Australian, French or AASHTO. Equation used for that strandards is probably hardcoded somew...

Add ability to create speed table based on minimum-maximum cant/cant deficiency and curvature.

We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...

When placing labels using the civil labeler, there are times when the label text location needs to be modified and moved to a different plan location to allow for other plan labels. When using civil labeler or the place label commands, after the l...

It is my understanding that this was removed in the 2024 version due to general confusion, but I'd like it to be added back. If it is made toggleable, it can be turned off by default to avoid the aforementioned confusion, and this allows those tha...

I created the Civil Label for the 100’ elevation along a geometric element, but I want to be able to pick where the labeling starts and not at the start of the geometric element. I want to establish a target to start the 1st label at a prompted cl...

I would like a set of tools that I can measure and draw slopes with in the dynamic sections. I can use temporary dimensions for the active corridor elements only, but I would like to get the slopes of elements in adjacent corridors that are in my ...

In Drainage & Utilities, the 3D line and the 3D object for a pipes(conduit/link) is placed on same level. It would be great to have them on different levels - also because it can be a demand from from clients in Denmark, that the line is place...

Currently in ORD existing cant can only either be viewed graphically in the curvature diagram or from within the cant editor. Current workflows to annotate existing cant in profile require the projection of both left and right rails in the vertica...