Hi would be very helpful to get a lift vrs Slew report at set chainages along an alignment. This would help the designer see if they are designing enough lift in the track to achieve the slews, without going to the drawing production stage

Additional functionality is needed for Design Standards to be fully functional for project delivery. Some additional thins include: Allow Design Standards to be optionally assigned to Alignment Feature Definitions so Alignments are created with th...

The horizontal Geometry Replacer tool is a step in the right direction, but it needs to include support for replacing profiles as well or have a companion tool of some kind.

In the ‘Code Checker Results’, the program summarizes for each girder all the critical load combinations, AASHTO code and controlling performance ratio. As in some diaphragm locations, the program is stating the girder is controlled by fatigue and...

I agree that the excess reinforcement factors would be different for each POI and load case. That is one reason most engineers conservatively ignore that factor. A simple or temporary solution is to set that factor equal to 1. I believe that AASHT...

I would like to programmatically create a new EventPoint list for an alignment. Looking through the Bentley.CifNET.GeometryModel.Tools.Helpers methods, I found GetEventPointList(Alignment) that returns a List<Bentley.CifNET.GeometryModel.KeySta...

We need ability to label height difference between centerline and curb or other key-point in our type XS. Or ability to label curb or other key-point height relative to centerline.

I'm surprised ORD doesn't automatically include an interval at the point in which cut slope becomes fill slope or vice verse. MX did a great job at this but without this function earthwork slopes aren't correct and give strange results. It's not p...

Possibility to add/remove/change length of long sleepers sets in turnouts that are placed in a geometry. When you are working with existing geometry and there are turnouts with too long sleepers sets or if you by mistake place a turnout that has a...

I noticed that template ranges can overlap and there is no obvious indication that this is occurring. Ideally over lapping station ranges should highlight in red to draw attention to it.