For Segmental Bridge Modeling, Pier caps segments typically have diaphragms built in and are a different cross section than the other typical segments. OBM should allow this to be modeled.

Option to keep siding alignment start station in synch with mainline alignment as shown in the attached video

Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;

Currently in annotation group, the back/ahead tangent line drawn at the PI only has the option for a fixed length. We would like the ability to draw back and ahead tangents the full length from PC to PI to PC. This could apply to both horizontal a...

I would like to see some of the tools from OpenCities, mainly the ability to read a geodata base, integrated into OpenRoads. Since Bentley Map was removed from the Select Series application and not added to the OpenRoads, we have very little GIS i...

Current default setting shows Vertical Curve Parameter or K-Value below the parabola length in the dynamic display of a vertical alignment. The geometry report has to be run or the annotation must be displayed to see the available SSD. It would be...

For box shaped conduits, we need to be able to define top, bottom and side wall thicknesses independently. This allows modeling of box shapes which correspond to physical construction.

Currently, when using the Set Feature Definition tool to assign a Feature Definition to a non-civil element (ie a dumb MSCE line) it does not include the Item Types that are attached to the Feature Definition.

For the water supply project, in a situation where we have cast iron elements connected to the flange such as gate valves, hydrants, elbows, venturiers and plastic line pipes. There is no way to connect the two nodes directly through the flange. a...

Once clash detection has been completed in BIC and forms have been created for individual clashes, it would be helpful for OBM to help navigate designers to the locations within the model that a particular clash form is identifying. It would also ...