City of San Diego doesn't currently label the Profile Elevations of the bottom major gridline and the top major gridline. OpenRoads doesn't differentiate between top and bottom and middle major gridlines. A toggle to disable Top and Bottom would h...

It would be very helpful if we could save our frequently used slopes to a pull down list in the "create slope to target" tool dialogue. Currently you have to type in your desired Cut and Fill slopes every time you use the tool. It would be much be...

Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...

Add a separate limiting tension stress for the top of girders near interior supports. AASHTO LRFD permits the use of a limiting tension stress at the top of girders near interior supports for Service III different than the limiting tension stress ...

The Florida I-Beam (FIB) section library in LEAP Concrete has not been updated to reflect the latest standard revisions. In particular, the number of strand slots in the third row from the bottom (@ 7") is shown as 13 in LEAP, while the current st...

Add ability to create picklist that we can associate value to it. In parametric contraint we could chosse a parameter and this parameter have a pick list. This pick list could be associated to a value list and we could use it for dusply rules or o...

A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.

As in the geometry connector, the geometry builder needs to be able to fix certain elements