A particular state DOT utilizes an integral abutment detail where the end diaphragm over the abutment is cast as part of the deck slab pour to encapsulate the ends of the steel girders or PPC I-beams (eliminating abutment joints). This end pour ov...
In 10.11 R1 (10.11.00.115), the profile projection icon under the OpenRoads Model tab changes when the projection’s source reference file is detached. Once you detach the reference the profile projection loses its civil rule, thus the icon changes...
Ability to add a unit to multi unit corridor in the middle or edit the multi unit corridor
In the Release 2025 of OpenTunnel Designer we can add a unit at the start and at the end of a unit with a tunnel corridor but it is not possible to place this unit in the middle of it or adjust this with reopening the multi units created from an x...
Annotation of High and Low Points for Geometry and other Linears
For now, the annotation of High and Low Points is very limited:# only one Low Point is detected - multiple low points are ignored# its is a linear3D annotation, and snaps on the annotations are not ruled (this intent is to be able to place drainag...
Menu options should be same regardless of where User clicks and how much they zoom in
Please see attachment. Bentley needs to ensure same menu options should be available whether the user right-clicks at the top, bottom, or side, AND regardless of the zoom level used. Edit components should not go missing. -JMS
Certain Catchment properties can be stored as collections (composite time of concentration and rational C by Land Cover are 2 that come to mind). For individual catchments these collections can be opened and a report generated, however it is tedio...
Allow Stopping Sight Distance to be controlled uniquely by alignment
Currently the stopping sight distance uses configuation variables to control the eye height and object height which would affect all alignment for a specific project. Please allow various alignments to have different options for these settings. Fo...
New Station Offset report with offset alignment bearings, distance and area
The format is a common setup for offset alignment data. This format makes is easy to review data for a parcel. This is the report generated from the Station Offset/Base Report *(image attached) *The attached file M50 P73 FEE REPORT (generated from...
When creating a profile view from 2D Geometry, there is no way to show the Point Cloud data which may attached to the model. When performing a "Create 3D Cut" the Point Cloud Data should be displayed. The only work around I have found is to create...