If you check the "Do not Show Again" box and press OK to the warning message in OpenRoads SignCAD 2023, then you can add additional panels to the file without the warning message displaying. However, closing and reopening the file will cause the m...

The ability to copy an existing event point list in the Event Point List Dialog. Without the ability to copy the list, you have to manually duplicate an existing list by creating a new list, and then either selecting or typing in the location of a...

For now ORD Cross sections have limited capabilities compared to MS Clip volumes. Request is that ORD cross sections do inherit full capabilities of MS Clip volumes, including capability to define a thickness for point clouds and project the Point...

In Leap Steel Including shear studs or not in the negative moment regions, changes the results of the moment diagram for composite load cases. Not including shear studs in the negative moment regions, decreases negative moment values and increases...

contour labels that are upside down our difficult to read. It would be advantageous to have all labels orientated correctly on each sheet (regardless of the north direction).

I have brought the limitation to the Wind Load Auto Generation tool in the past, but this is becoming more important and an issue now, since I’ve been getting many comments from our clients and my coworkers on this. Currently, the wind load auto g...

The raw-xml is missing Latitude and Longitude information when creating reports. InRoads had this capability, but it appears to be missing from OpenRoads.

If an enhancement idea is identified during a case or a Blueprint session, it should be reported by the case manager or the blueprint manager, not the responsibility of the user. Crowd sourcing support for deficiencies found during one of scenario...

It can come situations, especially in investigations, when you need to break a complex alignment i two because several reasons as change number of tracks or decisions of other design of a railyard/shut yard. Today we have to break the complex whic...

You can attach a corridor to a new reference but not with a linear template. Either make this tool also work for Linear Templates or create the ability to do so some other way.